![]() SketchUp has decided that since the new rectangle wasn't touching anything (groups don't touch other geometry) you probably meant to do a Pushpull with Copy and get a new box with all outside faces on the outside. Delete the group and examine the new geometry. Draw a Rectangle on one of its faces and Pushpull that rectangle into a box. Select All and make it a Group (right click menu). You'll still have outside faces outside and inside faces inside. Orbit to the opposite side, delete the face and take a look. Try these experiments: use oFFset to place a smaller rectangle on one of your faces. You see that you have outside faces on the outside and inside faces on the inside. As you saw when you orbited, you are now looking at the outside of all six faces.ĭelete one of the faces and take a look. And it's a special copy mode that reverses the face of the copy before pulling. SketchUp has guessed that you probably want to create a 3D object, so it pulls in copy mode, whether or not you asked. Orbit around until you are convinced that your object is white on all six sides. Tap Ctrl again to turn off the copy mode. When that rectangle was stretched out, you might have guessed that the inside would face down. ![]() Oddly, the bottom is white.įaces have an outside and an inside. Orbit until you are well underneath your rectangle. Now you've probably seen that color enough to be familiar with it. Using the origin for one corner and dragging into the area of positive red and green is a good habit. When you drag out a Rectangle and SketchUp has no other hints as to where to put it, it is placed on the rg (red/green, blue=0) plane. Select all and Delete for these experiments. Pay attention-it will pull together soon. Here we'll begin by examining some odd things that happen on the rg plane. We're finally above ground, but the real fun won't start until we get to the carriage doors that complete this chapter. "Gosh, Martin was right! You folks are great!" would be good.Īdministrative note: If you haven't already done so, switch from the Getting Started toolbar to the Large Tool Set toolbar (View/Toolbars). ![]() (It will be near the top.) Look at your replies. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |